latex学习（1）

1、latex中插入图片（需要调用\usepackage{graphicx}和\usepackage{float}宏包）

\begin{figure}[H]   
	\small
	\centering
	\includegraphics[width=13cm,height=8cm]{fig31}
    %\includegraphics[scale=0.6]
	\caption{sensitivity analysis results of damping trend model} \label{fig-29}
\end{figure}

• 其中[H]是为了固定图片位置，htbp分别为：h 此处（here）t 页顶（top）b 页底（bottom）p 独立一页（page）
• 改变width和height的参数值来改变图片的大小，也可以改变缩放因子scale改变图片大小。

2、两张图片并排插入（调用\usepackage{subfigure}宏包）

\begin{figure}[htbp]
	\centering
	\subfigure[predicted cumulative diagnosis]{\includegraphics[height=6cm,width=7cm]{fig7}}
	\subfigure[forest daily additions]{\includegraphics[height=6cm,width=7cm]{fig8}}
	\caption{ change curve of daily new number and cumulative confirmed number}
	\label{fig-7}
\end{figure}

其中\subfigure[每个图片的标签或说明]{\includegraphics[height=6cm,width=7cm]{fig7}}，没有标签可去掉\subfigure。

 3、多张图片并排插入（与两张图片类似）

• 3张照片

\begin{figure}[H]
	\centering
	{\includegraphics[height=5cm,width=4.7cm]{fig10}}
	{\includegraphics[height=5cm,width=4.6cm]{fig11}}
	{\includegraphics[height=5cm,width=4.7cm]{fig12}}
	\caption{virus transmission process when the infection rate parameter changes}
	\label{fig-8}
\end{figure}

其中\label{}为标签（通常放在\caption后），\ref{}为引用图片

• 4张图片

\begin{figure}[H]
	\centering
	{\includegraphics[height=5cm,width=6cm]{fig13}}
	{\includegraphics[height=5cm,width=6cm]{fig14}}
	{\includegraphics[height=5cm,width=6cm]{fig15}}
	{\includegraphics[height=5cm,width=6cm]{fig16}}
	\caption{cellular automata grid diagram of different population sizes}
	\label{fig-16}
\end{figure}

 4、插入普通表格

\begin{table}[htbp]
	\centering  %居中排版
	\setlength{\tabcolsep}{2mm}  %调整表格列宽
	\caption{Effect of infection rate parameters on prevalence}\label{tab-8}
	\begin{tabular}{|c|c|c|c|c|} %l为左对齐，c为居中对齐，r为右对齐
		\hline 
		 & Infection rate & cure rate & New patient probability &Stable prevalence \\
		\hline
		group 1 & 0.1 & 0.1 & 0.01 &0.381 \\
		\hline
		group 2 &  0.3 & 0.1 & 0.01 & 0.756 \\
		\hline
		group 3 & 0.5 & 0.1 & 0.01 & 0.831 \\
		\hline
	\end{tabular}
\end{table}

\begin{table}[htbp]
	\centering  %居中排版
	\setlength{\tabcolsep}{5mm}
	\caption{consistency inspection RI value}\label{tab-3}
		\begin{tabular}{|c|c|c|c|c|c|c|c|c|c|} %l为左对齐，c为居中对齐，r为右对齐
			\hline 
			n & 1 & 2 & 3 &4&5&6&7&8&9 \\
			\hline
			RI & 0 & 0 & 0.58 &0.90&1.12&1.24&1.32&1.41&1.45 \\
			\hline
	\end{tabular}
\end{table}

 5、插入三线表

\begin{table}[H]
	\centering  %居中排版
	\caption{Notations used in this paper}      \label{tab-2}
	%\setlength{\tabcolsep}{12mm}{
	\begin{tabularx}{\textwidth}{C{4cm} X} \toprule[1.5pt]
		Scale  &  Meaning  \\
		\midrule[1.5pt]
		1  & Indicates that the two factors have the same importance compared to each other \\ 
		4  & Indicates that the former is slightly more important than the latter  \\
		5  & Indicates that the former is obviously more important than the latter  \\
		7  & Indicates that the former is more important than the latter \\
		9  & Indicates that the former is more important than the latter \\
		2,4,6,8  & Represents the intermediate value of the above adjacent judgment  \\
		reciprocal & If the factor $i$ to factor $j$ importance ratio is $a_{ij}$ , then the factor $j$ to $i$ factor importance ratio is $a_{ji}=\frac{1}{a_{ij}}$ \\
		\bottomrule[1.5pt]		
	\end{tabularx}
	%}
\end{table}

\begin{table*}[!htbp]
	\centering  %居中排版
	\caption{Determination of $SEIR^{CIA}$  model parameter values}      \label{tab-7}
	%\setlength{\tabcolsep}{12mm}{
	\begin{tabularx}{12cm}{X X X} \toprule[1.5pt]
%	\begin{tabularx}{\textwidth}{C{4cm} X X} \toprule[1.5pt]
		parameter  & numerical value & Setting basis  \\
		\midrule[1.5pt]
		$S$  & 1.3$\times$ $10^{7}$   & Xi’an population  \\ 
		$E$  &7 & E(0) Latency length \\
		$\beta$  & $10^{-6}$ & expert opinion \\
		$\rho$ & 0.5 &expert opinion  \\
		$\phi$ & 0.5 & expert opinion  \\
		$\epsilon$ & 0.2 & expert opinion  \\
		$\alpha$ & 1/7 & reference \\
		$\omega$ &0.01 & expert opinion \\
		$\eta$ & 0.9 & expert opinion  \\
		\bottomrule[1.5pt]		
	\end{tabularx}
	%}
\end{table*}

 居中：

\begin{table*}[!htbp]
	\centering  %居中排版
	\caption{Determination of $SEIR^{CIA}$  model parameter values}      \label{tab-7}
	%\setlength{\tabcolsep}{12mm}{
	\begin{tabularx}{15cm}{C{5cm} C{5cm} C{5cm}} \toprule[1.5pt]
%	\begin{tabularx}{\textwidth}{C{4cm} X X} \toprule[1.5pt]
		parameter  & numerical value & Setting basis  \\
		\midrule[1.5pt]
		$S$  & 1.3$\times$ $10^{7}$   & Xi’an population  \\ 
		$E$  &7 & E(0) Latency length \\
		$\beta$  & $10^{-6}$ & expert opinion \\
		$\rho$ & 0.5 &expert opinion  \\
		$\phi$ & 0.5 & expert opinion  \\
		$\epsilon$ & 0.2 & expert opinion  \\
		$\alpha$ & 1/7 & reference \\
		$\omega$ &0.01 & expert opinion \\
		$\eta$ & 0.9 & expert opinion  \\
		\bottomrule[1.5pt]		
	\end{tabularx}
	%}
\end{table*}